Cincinnati, OH · Circuit Breaker Buyers
Sell Circuit Breakers in Cincinnati, OH
Retired circuit breakers in Cincinnati is usually worth more than assumed. A large share of what gets sent to a yard as scrap actually resells into service, and the difference between those two numbers is frequently significant. We will tell you honestly which category yours falls into before you commit to anything.
Serving Cincinnati and metro- Location
- Cincinnati, OH
- Desk
- Circuit Breaker Buyers
- Ratings
- 15 A – 6,000 A, LV through 38 kV
- Offer
- Same business day
- Payment
- Before load-out
- Phone
- 954-740-1983
Plate 01
Circuit Breakers buyers serving Cincinnati
Cincinnati sits in Ohio, where AEP Ohio, FirstEnergy, Duke Energy Ohio, Dayton Power & Light feed the load and I-71, I-75, I-70, I-80 and I-270 carry the freight. Sites near those corridors cost us less to service, and that shows up in your offer rather than in our margin. Columbus, New Albany, Dublin, Cleveland and Cincinnati are routine stops and Cincinnati work routes with them.
Once an offer is accepted we schedule around your outage, not ours. Night, weekend and phased removals in Cincinnati are ordinary work. Crews arrive with their own rigging, lifts and containment, protect the floors and leave the room broom clean.
| Item | Detail |
|---|---|
| Ratings | 15 A – 6,000 A, LV through 38 kV |
| Scope | Molded case, insulated case, air, vacuum |
| Nameplates | Square D, Schneider Electric, General Electric, Siemens, Eaton, Cutler-Hammer, ABB, Westinghouse, Federal Pacific, ITE, Zinsco, Challenger, Allis-Chalmers |
| Condition | Working, retired, water-damaged or already dismantled |
| Minimum | One section, one unit, or a whole plant lot |
Plate 02
What we take out of Cincinnati sites
Molded-case breakers
15 A through 2,500 A molded-case breakers of every major line, bolt-on and plug-in, with or without trip units. Discontinued Federal Pacific, Zinsco, Challenger, ITE and older Westinghouse frames are in constant demand for repair work.
Low-voltage power and insulated case
Drawout and fixed low-voltage power breakers — GE AKR and Magne-Blast lines, Square D Masterpact and DS, Eaton Magnum, Siemens — 800 A through 6,000 A, with electronic or electromechanical trips. Matched sets from a single switchgear order are worth quoting together.
Ohio specifics
Ohio's steel, glass, rubber and automotive base created a deep installed inventory of General Electric and Westinghouse switchgear and busway, and the state's freight position makes consolidation efficient.
Plate 03
Nearby and related
Nearby Ohio coverage — crews serving Cincinnati also run to:
Plate 04
Cincinnati questions
What is the smallest job you will take in Cincinnati?
A single transformer, one switchgear section, a pallet of bus plugs or a few boxes of breakers is worth a call. Because we route crews across Ohio continuously, small Cincinnati pickups usually get added to an existing run rather than priced as a dedicated trip.
How fast can you get to a Cincinnati site?
Written offers go out the same business day in nearly every case. After acceptance, typical mobilization to Cincinnati is a few business days for a straightforward removal and one to two weeks for a full plant scope that needs phasing, rigging plans or utility coordination.
Do we have to disconnect the equipment before you arrive?
No. We handle removal. Your electrician or the utility performs the final isolation and we verify it; from there our crews lock out, cut and cap cable at the gland, unbolt the sections, skate them out and load them. If the Cincinnati room is still partly live we phase the work.
How do you handle transformer oil in Cincinnati?
Oil is tested, drained and manifested through licensed handlers, and you receive the documentation with your paperwork. PCB-suspect units go under a separate waste profile. Nothing is left on your pad in Cincinnati and nothing gets dumped — the handling cost is already in the offer.
When do we get paid?
Before the equipment leaves your Cincinnati dock. Wire, company check or cashier's check, whichever your accounting group prefers. On large phased projects we pay per load as it ships rather than holding everything until the end.
Form 1 — Request for Offer
Get a Written Offer
Send the asset list, or just describe what is in the room. We come back the same business day with a written, itemized offer.
Faster: call or text 954-740-1983
Email an asset list to electricalequipmentbuyers@gmail.com
Mon–Sat, 7am–7pm ET. We never resell your contact information.
Circuit Breakers in Cincinnati?
One call, one written offer, one crew. Payment before the trailer leaves.